Protective Coat for Ceramic Roller (Dry powder)

PC-L:Including base coat and cover coat.Paint the base coat and cover coat uniformly onto the roller surface by the ratio of 1:5, total thickness 1.0-1.5mm (Base Coat:0.2-0.3mm, Cover Coat:0.8-1.0mm).Paint the base caot first, when the base coat fully dry, then paint the cover coat. After pre-heat and dry, the roller can be used on the kiln directly. The roller coat can sufficiently protect the roller against the contamination of the glaze drop or other infectant. When the roller coat is found dirty, pull out the roller, easily strip the coat after cooling, then paint the coat onto the roller again, and the roller is fresh for use in another cycle.

Protective Coat for Ceramic Roller (Dry powder)

PC－D： Easily transport, including Base Coat and Cover Coat. Before application, mix the powder with water very well (Base Coat--1:2, Cover Coat--1:1). It is best to put the powder and water into the ball mill and grinding for 2 hours. Then filter the slurry with the 40 mesh screen so that the base coat reach 30 degree viscosity and the Cover Coat reach 65 degree viscosity.Paint the slurry onto the roller surface with thickness of 1.0-1.5mm (Base coat:0.2-0.3mm, Cover coat:0.8-1.0mm), paint the base coat first, when the base coat fully dry, then paint the cover coat.After pre-heat and dry, the roller can be used on the kiln directly. The roller coat can sufficiently protect the roller against the contamination of the glaze drop or other infectant. When the roller coat is found dirty, pull out the roller, easily strip the coat after cooling, then paint the coat onto the roller again, and the roller is fresh for use in another cycle.

Added: 20.11.2007 Offer viewed: 166 (hits)

 Other trade leads by this Member Related trade leads   Print this Page   Bookmark this ad !

Send an inquiry to Kane.tan relating to the offer by using bellow form:

Your name: * Email: * Your Company name: Tel: Fax: Address: Location (country): * Subject: * Message * The Security code: 8667 Type Security code into this field: