Pall Ultipleat High Flow Water Filter Hfu660uy100h

PALL ultipleat high flow water filter HFU660UY100H

Specifications of Pall Ultipleat High Flow Water Filter
 
---Outside Diameter: 6inch (150mm)
---Length : 20inch(528mm)          40inch(1022mm)       60inch(1538mm)
Material PP
Precision 1micron-100micron
Outer-diameter 6inch (152mm)
Length 30T/5micron 70T/10micron
Flow rate 40-3000 L / min
 
The large flow filter has a 6 inch./152mm large diameter, and is coreless, single open-ended with an inside to outside flow pattern.
The large flow filter diameter with big filter area insures to reduce the number of filter cartridges and the dimension of housing required.The long service life and high flow rate result in low investment and less manpower in many applications.
 
Applications of Pall Ultipleat High Flow Water Filter
 
---Prefiltration of RO, Pretreatment of sea water desalination.
 
---Condensate water filtration, hot water recovery in power generation.
 
---API,solvents, and water filtration in BioPharm market.
 
---The filtration of bottled water,high Fructose, edible oil,soft drinks, and milk.
 
---Paints and coatings, Petrochemical, Refineries.
 
---Microelectronics, film, fiber and resin.

Features of Pall Ultipleat High Flow Water Filter
 
---Gradient pore structure.
---Up to 110M3/H flow rate per filter cartridge for water filtration.
---Maximum 50% reduction of filter system.
---20inch/528mm, 40inch/1022mm and 60inch/1538mm lengths are available.
---All contaminants can be removed within the cartridge because of the flow direction.
 
 Material of Constructions
 
---Filter media: Pleated glass fiber, Pleated depth Polypropylene(PP)
                     pp Melt blown
---Support/Drainage: Polypropylene(PP)
---End caps: Glass fiber reinforced Polypropylene 
---Seal Material: EPDM,NBR
 
Performance   
 
---Removal Rating: 41 / 4 / 5 / 6 / 10 / 20 / 40 / 70 / 100 um
---Maximum Operating Temperature: Pleated glass fiber: 121°C
                                                  Pleated PP: 82 °C
                                                  Melt Blown PP: 65°C
---Maximum Differential Pressure: Pleated glass fiber: 3.4Bar at 121 °C
                                                      Pleated PP: 3.4Bar at 82 °C
                                                      Melt Blown: 1.03Bar at 65 °C
---Recommended Change out differential Pressure: 2.4Bar at 20 °C 
 
---Suggested maximum Flow of water:
                                                            20inch length: 660LPM
                                                            40inch length: 1,300LPM
                                                            60inch length: 1,900LPM